Sani.gar pavimenti sintetici - Arezzo
 
SANI.GAR - rivestimenti per il suolo
rivestimenti per il suolo
 
  New Heronib    
  Frontrunner    
  Frontrunner Plus   tappeti a moduli
  Flexitred   Clips di connessione

Floor Coverings

It is the solution to the problem of wet, slippery, dirty and irregular surfaces.
It improves the safety, hygiene and the usefulness of the surroundings.
It is available in 12 models specialised for industrial, sportive and commercial activities.
It is also available in different sizes and colour. External outline and hooks for attachment to the ground are available on request.


TECHNICAL INFORMATION ON VINYL

Excellent sound absorption

Composition Measurements Life-span
100% pure and flexible PVC – It is possible (on request) to manufacture a type of PVC that is adapted for contact with food.
It is a unique piece, minimum 10 metres with a variable width, following the basic model, from 50 to 122 cm
The PVC characteristics of the product ensure a long life span even in the case of extreme use.
Chemical properties Fire-resistant Temperatures resistant
PVC isn't porous and this prevents bacteria-growth. It is resistant to many acids, oil and alkaline substances.
It is resistant to flames in the norm of Bs 2782 method 140a/1992
It is resistant to extreme temperatures. Range from –23C to 60C (it is possible to have a 2% variation for higher temperatures)
UV resistant Electrical resistant Structure
PVC isn't degradable by UV rays.
The red ones however shouldn't be exposed to direct sunlight as it can melt.
Flexitred: 20 000 volts
Flexigrid: 14 000 volts
Vynagrip: 12 000 volts
Surfaces with various types of filling, also possessing anti-slip properties with open and close grid design.


CLEANING INSTRUCTIONS

  • Detergent
    The fluid degreasing products are indicated. The powder ones are not indicated, as it is difficult to remove and it leaves a visible layer on the surface.
  • Cleaning by vapour
    Spray a solution of detergent and water. Leave it there for a few minutes. Rinse it with a vapour jet. The optimal pressure of the jet should be 6894 Kn/m2. The temperature of water should be 100°C.
  • Cleaning by hand
    Spray a liquid detergent and leave it there for a while. You can use a hard brush to allow the detergent to have a deeper effect. Rinse with water.
  • Degreasing
    There are some methods of industrial cleaning that can be used, e.g. the cleaning methods used in the meat area.
    For e.g., if the floor is covered by a grease layer, the whole carpet can be soaked in a solution of hot water and degreasing detergents. Brush it with a bristle brush and rinse with clean water.

 

Web designer SANI.GAR
 
Web designer SANI.GAR